mike
Junior Member
Posts: 67 
|
Post by mike on Oct 5, 2016 15:00:17 GMT -9
I also added a billet accumulator last time I dropped the valvebody. Best shifting tranny I've done yet.
Next tranny mod will be a break over TV lever. Brad Ponci was kind enough to share some picks of what his looks like.
|
|
mike
Junior Member
Posts: 67
|
Post by mike on Oct 5, 2016 15:03:18 GMT -9
|
|
mike
Junior Member
Posts: 67
|
Post by mike on Oct 5, 2016 15:10:19 GMT -9
This would let you ramp up your line pressure faster without damaging the TV valve or stretching the TV cable . TV = throttle valve. It's Hooked up to the throttle linkage and is the kick down cable . It moves in relationship to the accelerator pedal. If I have mine setup to tight it bottoms out the TV valve in the valve body. This lever would allow you to put full pressure on the TV valve earlier and the lever will break over itself will start to flex. Finding the right tension spring will be the difficult part. My shift points are pretty good right now but Id like to try out this lever.
Later shifts and more holding pressure for the clutches are the goal.
|
|
mike
Junior Member
Posts: 67
|
Post by mike on Oct 27, 2016 18:47:37 GMT -9
700 miles on Tranny -so far so good. My new headbolts showed up, also my new 140 gph pusher pump. I'll take plenty of pics
|
|
mike
Junior Member
Posts: 67
|
Post by mike on Feb 19, 2017 9:32:56 GMT -9
Truck is running great. Added new 7mm delivery valves for a nice 30cc bump in fuel. Have not installed the grade 12 head bolts yet. Waiting for the warmer temps before I bump the timing up.
|
|
mike
Junior Member
Posts: 67
|
Post by mike on Feb 19, 2017 11:04:11 GMT -9
Picked up a used wet shot fogger kit . Bought a new solenoid off eBay. I also have been gathering parts for installing a drive pressure gauge.  |
|
mike
Junior Member
Posts: 67
|
Post by mike on Feb 19, 2017 11:09:31 GMT -9
Cheater solenoid. Between it and my 3an feed line I'll be limited to around .091" of flow. Still good enough for 200ish hp. I'm gong to start with a .050" jet and take baby steps I'm also considering make a 2 stage kit  |
|
